Debug setup in RDi

[tbullard52561]

Used RDi at my previous employer (v 7.5) and now at my new job. Something has changed in my setup and I can't figure out what. When I set a service entry point in remote systems explorer to debug and ILE Rpg pgm - when the debug session starts - two code windows open - one is the "debug" view of the code where I can hoover/highlight a var for example and see the value. However - I am now getting a second window open showing the actual source code. When I "step through" the code - it steps through the 2nd window and this view does NOT allow me to see my variables - I have to toggle back to the first window and as soon as I continue stepping - it goes right back to the 2nd window. What have I inadvertently changed as this was not the prior behavior and I can't figure out how to stop it.

Thanks in advance

tb

[MichaelCatalani]

Re: Debug setup in RDi

Under Window / Preferences / Run-Debug / View management, check to see which windows are checked. You probably only want the debug window.